Do "I" need to decarb?


Here’s an interesting post from Do "I" need to decarb? : I have a 2000 Evinrude 225 that has about 300 hours. Since I don’t fish the only time the motor is at slow RPM is in no-wake zones. Otherwise I run at 4000 – 4500+ RPM and at least WOT for a few minutes each time I am...

Prop ?


Here’s an interesting article from Prop ? : Any suggestions appreciated. 36′ Stamas Express running healthy, new (long blocks) Mercruiser 502 Mag MPI’s with rated HP of 415 propped with Nibral 4-blades that have a slight cup Runs very smooth with no vibration, good low speed handling,...

225 OX66 gear oil overflow?


Here’s an interesting article from 225 OX66 gear oil overflow? : My ’99 225 OX66s have been on the lift for about two weeks with the engines trimmed full up. I lowered the engines to gain access to the bilge. When I lowered the engine to the full down position a small trickle of clean gear...

Power-vent surface drive system


Here’s a new article from Power-vent surface drive system : Going through types of drives …came across these one!! Dose any one has more knowledge on this type of drives? See,s like a good alternative to the conventional drive system with (maybe) grater shaft/prop protection. Attached...

« Previous Entries